![]() The module can only be reprogrammed to a more Selected and programmed, the controller cannot be reprogrammed to aĭifferent calibration. A Diagnostic Trouble Code (DTC) will beĬAUTION: Extreme care must be taken when programming a calibration into a ![]() Will not operate the engine until it is programmed. Replacement ofįuture PCMs will require programming utilizing the DRBIII and TechCONNECT. Modules will no longer be pre-programmed when received from Mopar®. Mopar® is currently phasing out pre-programmed PCMs for the vehicles listed. I have flash DVD for the DRB III, hopefully I will get it and can then do programming on a “swap” system. Look here: Procedure in detail will be of interest to those contempating a PCM changeĪfter reading this, it is obvious that PCMs can be reprogrammed.
0 Comments
Leave a Reply. |